A reply to some client questions.

added by russ on September 9, 2016 at 08:39

Copied here because many of the questions are fairly common ones!

All our craft use Briggs & Stratton Vanguard engines.  Built in Japan by Daihatsu, they are low revving four-strokes, which means decent noise levels and very good economy. Snappers use around 4-5 litres of fuel an hour, Marlins maybe 6-7 (much less than a jet ski!) They use regular UK/US pump fuel, no need for anything special.  Both will get around 2-4 hours from a fuel tank (12 litres on Snapper, and 25 on a Marlin) but of course it depends on conditions, payload, wind and the driver.

Maintenance is (in brief) as follows.

Pre-operation, check the craft over. Visually inspect skirt fix and wear, oil levels, fan condition, belt etc. Takes a couple of minutes per craft.

After a days operation in salt water, wash the craft off thoroughly with fresh water. Allow five minutes per craft.

If skirt needs maintenance, you can change each segment individually (approx. 58 on a Marlin/52 on a Snapper) and it takes just two minutes. The skirt – on water – will last a very long time, you’re likely to get well over a year from them. Sand/Mudflats/gravel obviously wear it faster but its top quality material and designed especially for us by a 'technical materials' company.

At 50 hours, change the oil, adjust tappet clearances, check fuel and air filters, replace if necessary.

How long do they last?

We have customers operating with over 600 hours on their engines, mechanically they are very robust (they are for plant/commercial use remember!) but you may replace ancillaries such as carburetors/coils etc in time. A whole new engine is only £1250.00UK so its not an expensive purchase if the worst happens. I’d certainly hope you got 5-10 years use from the craft, but of course, it depends largely how well they are looked after and the hours they clock up. We keep absolutely everything to build them (of course!) so there's nothing cannot be replaced, even the hulls which (to answer your next question) are built from GRP Fibreglass.

Wave capacity

It's difficult to be too precise about but they are all okay in a ‘chop’ – you must remember they are only small – so whatever you may be comfortable in a small boat of the same size, the hovercraft will be okay too. It’s a common question, and you may find this interesting and useful. http://britishhovercraft.com/UploadedFiles/hovercraft%20performance%20and%20information.jpg Also our FAQ page - http://britishhovercraft.com/Buy-A-Hovercraft/Frequently-Asked-Questions.aspx

Which Marlin?

For your use I’d recommend the Marlin ‘Beast’ – it has lots of extras and has more 'kerb appeeal' than the Marlin II Freestyle. The Marlin III is the best of everything, but it costs more money and isn’t really necessary for your purposes.

Marlin II : £9,500.00 - No frills, all thrills hovering!

35bhp Briggs & Stratton Engine

Yellow beacon

Bilge Pump

Jockey Seat for two

Hour meter

Kevlar reinforced floor

Internal Buoyancy foam

Limited range of colours. White hull with either blue or red trim.

 

 

 

The Beast : £11,000.00 - As driven by Jeremy Clarkson!

As above but with the additions of

37bhp Hi-Torque 'Savage' engine.

Rear 'T' Seat - more seating for up to three people.

All-round LED white light and navigation lights.

LED Headlights.

Rubber non-slip flooring.

Improved endplate rudders.

Tacho/Rev Counter.

GPS Speedo/heading compass.

Wide range of hull and secondary colours .

 

 

Marlin III : £12,500.00 - The ultimate yacht tender!

As 'The Beast' but with the following additions.

Upgraded, stiffer hull with integrated screen, revised splitter plate to reduce noise and add additional lift, larger receiver area to give improved plenum flow characteristics.

 

 

Lots more answers to many more question on our website!

 

 

 

 

The Hovercraft Code of Practice is now law! CoP24.

added by russ on December 9, 2015 at 12:08

Great news received from the MCA today. The Hovercraft Code of Practice is now formally adopted and has been given the catchy title of CoP23. To us it remains the 'hovercraft code.' You can download it from the MCA website HERE

This 100 page document has been prepared over three years between the British Hovercraft Company, Griffon Hoverwork, the Hovercraft Manufacturers Association, Lloyds, the MCA and other contributors such as The Hovercraft Museum and The Hovercraft Club of Great Britain.

It really does change everyhting, small hovercraft can now be coded for commercial operations using clear, industry lead standards and methods. The first part of the hovercraft code explains what catagories hovercraft go into for each role - be it commercial hovercraft, rescue hovercraft, recreational hovercraft craft or even racing and 'days out' stag and hen driving experiences! It's all in there and clarifies exactly how hovercraft operators can get their hovercraft coded for commercial operations.

So, after three years work, and dozens of meetings and hundreds of hours of work behind the scenes, today has seen all the hard work come good. It opens the way for small hovercraft to really show their potential and step up for intertidal work such as survey, crew transfer, sampling, security and anything else where fast, safe intertidal transport is required.

We do now provide this service - hovercraft hire - through our subsidiary Coastal Transit Services www.coastaltransit.services

If you have any questions on the code, please don't hesitate to contact us!

 

 

 

 

 

https://www.gov.uk/government/publications/the-hovercraft-code-of-practice-cop-23


Search


Categories

None


Tags


Archive


Recent Posts